![[USB3-MR01A] USB3.0 Micro-AB Receptacle Fixture](http://litektw.com/uploads/tadgallery/small/2011_09_27/19_s_USB3-MR01A_USB3-MicroAB-Receptacle.jpg "[USB3-MR01A] USB3.0 Micro-AB Receptacle Fixture")
![[HDMI-DP01A] HDMI1.4 Type D Plug with Power Fixture](http://litektw.com/uploads/tadgallery/small/2011_09_08/16_s_HDMI-DP01A_HDMI1.4-TypeD-Plug-with-Power.JPG "[HDMI-DP01A] HDMI1.4 Type D Plug with Power Fixture")
![[HDMI-DR02AM] HDMI1.4 Active Type D Receptacle Fixture](http://litektw.com/uploads/tadgallery/small/2012_04_05/101_s_HDMI-DR02AM_HDMI-Active-TypeD-Recpetacle-TF.jpg "[HDMI-DR02AM] HDMI1.4 Active Type D Receptacle Fixture")
![[LT-100R-20GD-5P] 5Pair 20G Raw Cable Fixture Set](http://litektw.com/uploads/tadgallery/small/2019_04_16/176_s_5pair20GD.jpg "[LT-100R-20GD-5P] 5Pair 20G Raw Cable Fixture Set")
![[SAS-MR01AM] Mini SAS 4i Fixture](http://litektw.com/uploads/tadgallery/small/2012_04_05/106_s_SAS-MR01AM_MiniSAS-4i-TF.jpg "[SAS-MR01AM] Mini SAS 4i Fixture")
USB2/3/4
|
| ||||||
|
| |||||
|
Hit Rate 4458
[DPA-12] DP Probe Fixture
LiTek's DPA-12 is a good probe test fixture for Display-Port Source and Sink signal quality and protocol testing. Not only 4 Lane pairs, Aux Channel, but also all low frequencies signal pins had been extended to the SMA connectors and the 2.54-mm pitch connector.
Since the pin assignments are reversed in Source and Sink sides. DPA-12 probe test fixture is labeled with SLXX for Source end and with LLXX for Sink (Link) end. Downloads [DPA-12] DP Probe Test Fixture Datasheet | ||||||
