| |||
Hit Rate 1735
[PRB-100-P10-2BM] Differential Probe 1.0 Pitch
Impedance and Loss measurements on PCB
become more and more important when the data rates increased. To get the pure loss of the PCB traces based on the assigned length, especially in the inner layer is very difficult because How to remove the via hole and probe effects is an issue. However, if the probe itself can’t be maintained with a linear behavior, anything is invalid to discuss. Fig2: Probe on the holder Litek’s PCB test probe PRB-100-P10-2BM is a selection for the user to measure the PCB Impedance and Loss. We defined the guide pin and the contact pads for the user to design the PCB traces. A preferred assistant structure is defined that the probe can be easily putted on the right position. Downloads PRB-100-P10-2BM Differential Probe 1.0 Pitch Datasheet-Eng |