![[USB3-AR03AM] USB3.0 CTS Type A Fixture](http://litektw.com/uploads/tadgallery/small/2012_04_13/108_s_USB3-AR03AM_USB3.0-CTS-TypeA-Rec-Fixture.JPG "[USB3-AR03AM] USB3.0 CTS Type A Fixture")
![[LT-6000] SATA III Probe Adapter Fixture](http://litektw.com/uploads/tadgallery/small/2009_08_05/40_s_LT-6000_SATAIII-Probe-Adapter-TF.jpg "[LT-6000] SATA III Probe Adapter Fixture")
![[HDMI-AP02AM] HDMI1.4 Type A Plug with Power Fixture](http://litektw.com/uploads/tadgallery/small/2011_12_14/83_s_HDMI-AP02AM_HDMI-Active-TypeA-Plug-TF.jpg "[HDMI-AP02AM] HDMI1.4 Type A Plug with Power Fixture")
![[QSFP-R07BR] QSFP28 Rec Active Fixture](http://litektw.com/uploads/tadgallery/small/2017_07_20/156_s_qsfp.jpg "[QSFP-R07BR] QSFP28 Rec Active Fixture")
![[LT-100R-40G-30C] 40G Raw Cable Fixture](http://litektw.com/uploads/tadgallery/small/2020_03_04/180_s_LT-100R-40G-30C.jpg "[LT-100R-40G-30C] 40G Raw Cable Fixture")
![[DPR-12B] DP Receptacle-End Fixture](http://litektw.com/uploads/tadgallery/small/2011_11_21/43_s_DPR-12B_DP-RecEnd-TF.jpg "[DPR-12B] DP Receptacle-End Fixture")
![[HDMI-CK02A] HDMI1.4 Active Calibration Kit](http://litektw.com/uploads/tadgallery/small/2012_04_16/117_s_HDMI-CK02A_HDMI1.4-Active-Cal-Kit.jpg "[HDMI-CK02A] HDMI1.4 Active Calibration Kit")
USB2/3/4
|
| ||||||
|
| |||||
|
Hit Rate 3438
[DPA-12B] DP Probe Plug-End Fixture
LiTek's DPA-12B is a good probe test fixture for Display-Port Source and Sink signal quality and protocol testing. Not only 4 Lane pairs, Aux Channel, but also all low frequencies signal pins had been extended to the SMA connectors and the 2.54-mm pitch connector.
Since the pin assignments are reversed in Source and Sink sides. DPA-12B probe test fixture is labeled with SLXX for Source end and with LLXX for Sink (Link) end. Downloads [DPA-12B] DP Probe Plug-End Test Fixture Datasheet | ||||||
