![[MHL-CK01AM] MHL Calibration Kit Fixture](http://litektw.com/uploads/tadgallery/small/2011_07_25/31_s_MHL-CK01AM_MHL-Calibration-Kit-TF.JPG "[MHL-CK01AM] MHL Calibration Kit Fixture")
![[DPA-12] DP Probe Fixture](http://litektw.com/uploads/tadgallery/small/2009_08_05/44_s_DPA-12_DP-Probe-TF.jpg "[DPA-12] DP Probe Fixture")
![[PRB-100-P10-2BM] Differential Probe 1.0 Pitch](http://litektw.com/uploads/tadgallery/small/2016_03_24/178_s_Prb-100-P10-2BM.jpg "[PRB-100-P10-2BM] Differential Probe 1.0 Pitch")
![[HDMI-AP01AM] HDMI1.4 Type A Plug Fixture for Tektronix](http://litektw.com/uploads/tadgallery/small/2012_04_05/96_s_HDMI-AP01AM_HDMI-TypeA-Plug-TF-ForTektronix.jpg "[HDMI-AP01AM] HDMI1.4 Type A Plug Fixture for Tektronix")
![[HDMI-DR01A] HDMI1.4 Type D Receptacle Fixture](http://litektw.com/uploads/tadgallery/small/2011_12_13/77_s_HDMI-DR01A_HDMI1.4-TypeD-Rec-TF.jpg "[HDMI-DR01A] HDMI1.4 Type D Receptacle Fixture")
USB2/3/4
Introduction
LiTek's DPR-12B is a good receptacle-end test fixture for Display-Port Source and Sink signal quality and protocol testing. Not only 4 Lane pairs, Aux Channel, but also all low frequencies signal pins had been extended to the SMA connectors and the 2.54-mm pitch connector.
Since the pin assignments are reversed in Source and Sink sides. DPR-12B probe test fixture is labeled with SLXX for Source end and with LLXX for Sink (Link) end.
Downloads
Count3720
|
|
|
|
|
11-24 [DPA-12] DP Probe Fixture
The comments are owned by the poster. We aren't responsible for their content.