Introduction

　LiTek's SW4032A Test System Consist of two parts, Coaxial Switch Box and RF Test Fixtures. Using the Coaxial Switch Box the customers can enhance the performance and reduce the complex of the testing.

　The SW4032A Switch Box provides 4 X 1 to 8 switches, mostly working with Network Analyzer and used to expand from 4 Ports to 32 Ports. In other words, it can be used to test 2 pairs of differential signals. Fixture set will be optionally selected based on DUT type.

　LiTek's TpNA_Express software is well designed to control SW4032A and Network Analyzer. It can be used to build project, recall project, do calibration and output reports.

Read More...

Introduction

　LiTek's SW2012A Test System Consist of two parts, Coaxial Switch Box and RF Test Fixtures. Using the Coaxial Switch Box the customers can enhance the performance and reduce the complex of the testing.

　The SW2012A Switch Box provides 4 X 1 to 2 switches, mostly working with Network Analyzer and used to expand from 4 Ports to 8 Ports. In other words, it can be used to test 2 pairs of differential signals. Fixture set will be optionally selected based on DUT type.

　LiTek's TpNA_Express software is well designed to control SW2012A and Network Analyzer. It can be used to build project, recall project, do calibration and output reports.

Read More...

Introduction

　PLT3045A is a tester/programmer which is desiged to test/program HDMI active cable using Synerchip SC2031Q HDMI cable booster chip. The PLT3045A test the HDMI active cable Bit Error Rate (BER) from low bit rate up to 3.4Gbps, find an optimal setting for SC2031Q and program the cable using the optimal setting. The PLT3045A control software implement learning capability to select some best settings for certain type of cable and store the selected settings for later testing the same cable type. There are a lot of setting implemented in Synerchip SC2031Q cable booster to adapt to different cable loss. By the learning capability, the PLT3045A can save a lot of cable test time.

Read More...

Introduction

　PLT2050D (High Speed Transmission Analyzer) is a powerful online testing machine. Based on real TMDS Tx and Rx protocol and high performance image processor, it can be used to test DVI/HDMI cable assembly in very short time. By this way, you will increase the competitiveness to the market. 

　The TX transmitter encodes parallel data and serially transmits an input data stream over a T.M.D.S link (DVI / HDMI Assembly) to the RX receiver. Then PLT2050D compares the different between input Streams and Recovered Streams, and show the result on the LCD platform.

Read More...

Introduction

　PLT3050A (USB 3.0 Cable Production Line Tester) is a powerful online testing machine. Based on real 5Gbps Data rate and high performance processor, it can be used to test USB 3.0 cable assembly in very short time. By this way, you will increase the competitiveness to the market.

Read More...